Electricity And Safety; Characteristics - Diamond3 3510 Bedienungsanleitung

5. During sawing with this sawing machine the
max. sound pressure level is exceeded.
Because the max. sound pressure level is
exceeded during operation wearing
hearing protection is mandatory.
6. The safety label on the machine should
never be removed.
7. In addition to the above mentioned safety
regulations the user should pay attention to
the following items:
Read the instructions for setting up and
using the machine carefully.
Check that the power cord is correctly con-
nected to the power supply.
Electrical cables may not come in contact
with water or spray water.
Damaged saw blades should be replaced
immediately.

4.ELECTRICITY AND SAFETY

ATTENTION!
On construction sites electrical appliances
should be connected to specially designed
power supplies. Suitable are grounded main
power supplies equipped with an earthleak
switch of max. 30mA or separating transform-
ers. Non-grounded common household or sim-
ilar power outlets are not suited as a power
source.
For water cooled sawing machines stricter
safety standards are applicable. Therefore, for
extra safety the machine must be connected
according to one of the following methods:
Main power supply equipped with earthleak
switch 30 mA.
--------------------- or ---------------------
Separating transformer, only 1 machine may
be connected at any given time
17
OPERATING MANUAL
--------------------- or ---------------------
With an intermediate cable equipped with a
PRCD safety switch of max. 30mA.

5.CHARACTERISTICS

Machine construction
The stainless steel construction contributes to a
stable, rigid and durable sawing machine. The
detachable legs are to be installed in the leg
sockets at the underside of the water container
and fastened with the knobs.
Saw head
The saw head is constructed of welded steel
components. The height adjustment of the saw
head is kept in balance by a spring. Two han-
dles secure the saw head at the desired height.
GB
Rev. 1