Unpacking And Set Up - Diamond3 3510 Bedienungsanleitung

GB
Saw cover
The saw cover is a welded steel plate cap, sim-
ple to remove and install for changing the saw
blade by unscrewing 2 knobs.
Saw spindle
The motor flange is mounted on the saw spin-
dle. The saw flange is to be mounted on the
saw spindle with a hexagon nut to clamp the
saw blade. (Attention: Left-handed screw
thread)
Saw table
The saw table is constructed of welded stainless
steel components, equipped with anti-slip rub-
ber and adjustable side stop.
Cooling system
The electrical water pump is switched on simul-
taneously with the saw motor and supplies
cooling water to both sides of the saw blade. A
drain hole, with a plug, is located in the water
container. The mud flaps prevent most of the
water mist and make sure most water flows
back in the water container.
OPERATING MANUAL

6.UNPACKING AND SET UP

Setting up
Saw head
Unpack the sawing machine and inspect for
any damaged parts.
Install the legs in the sockets at the under-
side of the water container and fasten with
the knobs.
Level the sawing machine by adjusting the
legs in the sockets and make sure its stable.
Unscrew the transportation lock.
By loosening the two handles the saw head
can be positioned at the desired height.
ATTENTION!
The saw head is tightened by a spring
and may accidentally jump up when the
handles are loosened.
18