Anti Frost; Vacation; Boost - SCDI TEMPCO RF CONTROL Bedienungsanleitung

perature in the room for 10 seconds, the symbol also
displays.
ANTI -FROST TEMPERATURE OPERATING
MODE
This mode prevents the system from freezing. It allows
a minimum temperature to be maintained during a
prolonged absence.
Select this mode using the "+ or -" buttons then press
OK. The temperature setpoint appears on the screen.
To modify this, press the OK button again and the tem-
perature fl ashes. Use the "+ or -" butt on to adjust it
then press OK to accept.
The ambient temperature appears for 10 seconds fol-
lowed again by the temperature setpoint. The tempe-
rature range can be between 5°C and 10°C.
Pressing the back button displays the ambient tem-
perature in the room for 10 seconds, the symbol also
displays.
VACATION OPERATING MODE
This function allows you to set your heating sys-
tem to your desired temperature while you are
away and is set using the following 4 steps:
1. Select this mode using the "+ or -" buttons then
press OK. The temperature setpoint fl ashes on the
screen.
Use the "+ or -" buttons to adjust the desired tem-
perature to maintain during your absence and
then press OK to accept.
2. Now set the end date for your vacation starting
with the month. Use "+ or - to adjust then press
OK to accept. (Note: the year changes when you go
below the fi rst month or above the twelft h.).
3. Set the day your vacation ends. Use «+ or -» to
adjust then press OK to accept.
4. Set the time your vacation ends. Use «+ or -»
to adjust then press OK to accept. (Note: set to
hours only); Your vacation end date appears on the
screen and the vacation symbol fl ashes
You can exit vacation mode at any time by pressing
the back button for 2 seconds. You will be returned
to the previous mode.
BOOST OPERATING MODE
This function allows you to manage rapid tem-
perature increases in your radiator at any ti me
and for a defi ned period without modifying your
programs.
Select this mode using the "+ or -" buttons then
press OK. A period of 30 minutes fl ashes on the
screen. Use the "+ or «-" buttons to adjust the
desired period in steps of 10 minutes. The set pe-
riod range can be between 10 and 120 minutes.
Press OK to accept.
EN
9