Transmitter; Descripti On Of Transmitter Modes (Remote Control); Auto - SCDI TEMPCO RF CONTROL Bedienungsanleitung

TRANSMITTER

Remove the protective flap from the remote control bat-
teries. During first startup, the appliance starts in comfort
mode. When changing flat batteries and a long period has
elapsed (more than 2 minutes), the appliance starts in the
previous operating mode.
The first step is to adjust the time on your remote control.
This adjustment can be made from any mode and at any
time.
Press and hold the OK button for 5 seconds until the time
appears. Release it then press the OK butt on again.
The hour figure flashes. Use the «+ or -» buttons to adjust
then press OK to accept.
The minute figure flashes. Use the «+ or -» buttons to ad-
just then press OK to accept.
The day of the week flashes. Use the «+ or -» buttons to
adjust then press OK to accept.
The date flashes. Use the «+ or -» buttons to adjust then
press OK to accept.
The month flashes. Use the «+ or -» buttons to adjust then
press OK to accept.
The year flashes. Use the «+ or -» buttons to adjust then
press OK to accept.
You will now be returned to the previous mode after accepti
ng the final setting. The time, date and year are now set on
your remote control. They will be used in Auto and Vacation
modes.
Note: Setting the time is not necessary if your remote
control is paired with the E3 program controller (sold separa-
tely), as the time is automatically synchronized.
To view the adjusted time, press and hold the OK butt on for
5 seconds unti l the time appears. It will remain displayed for
10 seconds before returning to the previous mode.
Important: You can always cancel the last setting by pres-
sing the Back butt on. Also note that if the screen's back-
ground light is not turned on, simply press any button to
activate it.
To establish communications between the transmitter
(Remote Control) and the receiver (Thermostat) follow the
instructions below. This operati on is also known as pairing.
The radiator must be turned on.
On the thermostat:
Press and hold button «B» on the thermostat for 5 seconds.
Indicator light «A» flashes orange slowly. This is the signal
to release button «B» as the radiator is now in pairing
mode.
On the remote control:
1. Press and hold the OK butt on on the remote control for
10 seconds unti l the installer menu appears «bL no», the
symbol appears.
2. Press the « + » button once, «rF INI» appears on the
screen. You are now at the pairing menu.
3. Press the «OK» butt on once, «INI» and the symbol
start flashing on the screen. Your radiator is currentl
4. You can pair another radiator by repeating the pre-
vious steps (On the thermostat and on the remote
control).
Note: You can access the installer menu from any
mode.
Important: If you have an E3 program controller (sold
separately) installed in your system, always pair the
remote control first then the radiator in accordance
with the operati ng modes described above and in the
E3 instruction manual.
DESCRIPTION OF
TRANSMITTER
MODES (REMOTE CONTROL)
COMFORT TEMPERATURE OPERATING
MODE
EN
7