Starting The System; Receiver; Receiver Indicator Light Status; Confort - SCDI TEMPCO RF CONTROL Bedienungsanleitung

STARTING THE SYSTEM

RECEIVER

Connect your appliance to the electricity supply. Press button «B» located on the receiver at the bottom of the ap-
pliance to start the radiator. Indicator light «A» is illuminated and you will hear 2 short «beep» sounds. Pressing button
«B» again will turn off your radiator and produce a long «beep» sound. Indicator light «A» goes out, and no communi-
cation with the remote control is possible.

Receiver indicator light status

Operating mode
Standby

Confort

Anti-frost
Confort -1°C (*)
Confort -2°C (*)
Pairing mode
Sensor fault or
Measured temp. > 35°C
The RF receiver is fitted with an independent regulation system which saves status information (start/standby) and tem-
perature setpoints to its memory. Storage of the last received setpoint ensures the temperature is still regulated even if
the transmitter is turned off or its batteries exhausted. Also note that during a power outage to the radiators, pairing does
not need to be reiniti alized.
Important: If your receiver is turned off , your radiator will not receive any commands from the remote control.
Eco
Slow flashing green
Double flashing green
Double slow flashing
Indicator status
Radiator paused
Off
Steady green
Flashing green
green
Flashing orange
Flashing red
Indicator status
Radiator Heating up
Steady red
Flashing red-green
Slow flashing red-
green
Double flashing
redgreen
Double slow flashing
red-green
Flashing orange
--
EN
6