Eco - SCDI TEMPCO RF CONTROL Bedienungsanleitung

Designed to be used when people are occupying the
room or may soon be.
Select this mode using the "+ or -" buttons then press
OK. The temperature setpoint appears on the screen. To
modifythis, press the OK butt on again and the tempe-
rature fl ashes. Use the "+ or -" butt on to adjust it then
press OK to accept.
The ambient temperature appears for 10 seconds fol-
lowed again by the temperature setpoint. The tempera-
turerange can be between 5.5°C and 30°C. A three-color
visual behavior indicator displays during adjustment to
inform you which temperature ranges involve low, me-
dium or high energy consumpti on and allow you to save
energy.
Green: Low consumption, temperature between 5.5°C
and 19°C
Orange: Medium consumption, temperature between
19.5°C and 24°C
Red: High consumption, temperature between 24.5°C
and 30°C
This visual indicator allows the user to be aware of the
risk of excessive energy consumpti on when setti ng the
comfort temperature.
The temperature you have set it to is the desired room
temperature for this operating mode. You need to wait
several hours for the room temperature to become
stable again.
Pressing the back button displays the ambient tempe-
rature in the room for 10 seconds, the symbol also dis-
plays.
AUTO TEMPERATURE OPERATI NG MODE
Designed to be used when people require automatic
and independent radiator operation as follows:
Priority 1: If the radiator is connected, control is via
the cable: Commands sent by EDF as part of an off
-peak contract
such as Tempo or other "6 level" energy manager, the
temperature is adjusted based on the comfort mode
temperature setpoint.
Priority 2: The program currently set on the E3 pro-
gram controller (sold separately) if the remote control
is paired with it.
Priority 3: A program previously selected in program
mode on the remote control (d1 to d9, U1 to U9).
You can at any ti me change the temperature setpoint
in your program by pressing the OK butt on. The tem-
perature then fl ashes on the screen. Change it using
the "+" and "-" butt ons then press OK again to accept.
In this case, you are now in timer exemption and the
symbol appears on the screen. Pressing the butt on
exits the exempti on and returns to the temperature
setpoint for your program. If not, the exempti on exits
automati cally after 2 hours.
Pressing the back button displays the ambient tem-
perature in the room for 10 seconds, the symbol also
displays.
ECO TEMPERATURE OPERATING MODE
Designed to be used when people are not occupying
the room or are unlikely to be.
Select this mode using the "+ or -" butt ons then press
OK. The temperature setpoint appears on the screen.
To modify this, press the OK butt on again and the
temperature fl ashes. Use the "+ or -" butt on to adjust
it then press OK to accept.
The ambient temperature appears for 10 seconds
followed again by the temperature setpoint. The tem-
perature range can be between 5.5°C and 19°C but
always 0.5°C lower than the comfort temperature.
The temperature you have set it to is the desired room
temperature for this operati ng mode. You need to wait
several hours for the room temperature to become
stable again.
Pressing the back button displays the ambient tem-
EN
8