Preparations; Adjusting The Push Bar; Setting The Cutting Height - Gardenline GLM43H Bedienungsanleitung

First use
4. Pull the rubber lips of the grass collection bag
5. Make sure that the lawn mower is completely assembled before operating it.

Preparations

1. Familiarise yourself with all controls as well as proper use of the machine. Keep in
mind that the machine operator is responsible for accidents associated with other
persons or their property. Before every use, always check the connection cable or
any extension cords for signs of wear and damage. If the cable is damaged during
use, it must be disconnected from the mains immediately and must not be touched.
2. Check that all screwed connections on the lawn mower are securely seated and
that the cutting blade is sharp enough.
3. Lift the protective cover
onto the lawn mower (see Fig. E).
4. Lay the entire mains cord out in loops, if possible next to the lawn.
5. Make a loop with the last approx. 40 cm of the mains cord.
6. Run the loop through the wide opening of the cable guide
(see Fig. F).
7. Slowly pull the loop against the cable guide to tighten it. If the cable is not taut, it
may become loose and slip out when working.
8. Connect the mains jack of the extension cord to the on switch (with mains
connection) 15
9. Insert the mains plug of the cord in a properly installed socket.

Adjusting the push bar

1. Loosen the two quick release units (push bar height adjustment)
2. Set the push bar
3. Make sure that the teeth of the fixing gears interlock correctly. Fold the quick
release unit in all the way to the stop point and if necessary, tighten it.

Setting the cutting height

You can use the lever for the cutting height adjustment to set the cutting height to
seven different positions from approx. 2 to 7 cm:
1. Pull the lever for the cutting height adjustment
2. Push the lever to the desired cutting height. This will lift or lower the entire lawn
mower.
3. Let the lever for the cutting height adjustment lock back into place.
14
13 all the way up and hook the grass collection bag
of the lawn mower.
1 and the push bar pole
5 over the steel frame.
2
4 to the desired height.
out of the catch (see Fig. G).
7
5
and over the hook
10 .