Wile Bio Moisture Gebrauchsanweisung Seite 8

EN
that average calculation memory is
empty and erase it if needed.
3.4.2. Erasing the average calculation
memory
Push and hold the MENU- button. Switch
on the meter with a single press on the
ON/OFF- button.
When you see A on the display, release
the MENU- button. If the average value
appears on the display now, you can
erase it by pushing and holding the
MENU- button. The memory is erased,
when 0 appears on the display.
Note! Always remember to erase the
average calculation memory after the
measurement series so that the
previous average value will not affect
the average value of the new lot.
Average calculation memory can
accomodate maximum 99 results. If no
more results can be added to the memory,
the number on the display will start
blinking.
3.4.3. Adjusting the result
If the quality of the measured material is
different from normal, the result can be
incorrect. You can adjust the result shown
by the meter to conform with a reference
value.
- Adjusting the value upwards
When the measurement result is
displayed make the double press on the
MENU- button. Three bars will appear