Wile Bio Moisture Gebrauchsanweisung Seite 4

EN
3. Taking the sample and carrying out
the measurement
3.1. Taking the sample
Log/sawdust (taken with a motor chain
saw)
Take the sample from a tree length log
with a motor chain saw (see pictures in
the appendix). Place the bucket for the
sample near the point of sawing so that
the sawdust goes straight into the bucket.
Always saw the tree crosswise.
Always use the appropriate protective
equipment and follow the safety
instructions of the motor chain saw
manufacturer.
Check that the saw blade is sharp
enough. Sawing with a blunt blade warms
the sample and can cause the wrong
measurement result.
Take the sample from different places of
the sawdust heap. Collect for about 0,5
liter of sawdust (see pictures in the
appendix). If you don't carry out the
measurement straight away, close the
bucket lid tightly. When collecting the
sample remember, that if some part of the
heap is covered, the material under the
cover is usually drier than the rest of the
material.
Before carrying out the measurement mix
the collected sample properly .
Pellets
Collect the sample from different places of