Battery Replacement - ebro MME 200 Bedienungsanleitung

Feuchtemessgerät

Vorschau ausblenden

Seite von 12

/ 12
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

Note:

- Do not take measurements on metallic linings!

- In corners or recessed areas a distance of ca.8-1 O cm from the edge/recess

must be maintained.

- If there is any metal in substructure(constructionaI steel, channels, pipes, pla-

ster rails, etc.) and with normal coverings, the display jumps to ca. 50 digits for

otherwise dry surroundings.

- It is only possible to reach a conclusion about the absolute dampness in wt-%

or the dampness in CM-% if the normal drying out process has taken place (e.g

not during or shortly after the use of drying agents or heat guns). If there is not a

roughly normal variation in dampness between the surface and the interior, too

low a measured value may be indicated.

- The raw density of the material being measured has a noticeable affect. Basically,

the value displayed with dry and damp building materials increases correspon-

dingly with increasing raw density.

- The values given in the table below are indicative and non-binding.P|ease bear in

mind, when evaluating the measured value displayed on the NON-Contact Moi-

sture Meter with respect to the material, that it is not a dampness measurement

qualiﬁ ed to VOB or the relevant specialist regulations.

- All information and tables in these operating instructions concerning permissible

or common dampness conditions in practice as well as the general deﬁ nition of

terms are taken from the technical literature. The manufacturer of the instrument

can thus not give any guarantee for the correctness of this information. The

conclusions to be drawn from the result of measurements by each user depend

upon the individual circumstances and his experience gained from professional

practice.

Construction material:

Gypsum

Cement