Operation; Buttons - G&D Rackconsole-Led 17Hr Installation Und Bedienung

Operation

How to operate the TFT drawer:
1. Use the handle to pull the drawer out of the rack.
2. Lift the display to activate it.
3. If necessary, press the device's Power button (see image 6 on page 3).
4. Set any resolution up to
5. After operation close the display, and slide the drawer back into the rack.

Buttons

MENU/SET Press this button to show the OSD during operation.
Press this button while operating the OSD to select a menu item or to save your set-
tings.
ESC/AUTO Press this button while operating the OSD to navigate to another menu level or to
leave the menu.
Press this button to auto-adjust the image settings while the VGA video signal is dis-
played.
 Press this button while operating the OSD to select the menu item above the active
menu item.
Press this button to increase the value shown on a scale.
 Press this button while operating the OSD to select the menu item under the active
menu item.
Press this button to decrease the value shown on a scale.
ON/OFF Press this button to turn the RackConsole on or off.
.
1920 × 1200 @ 60 Hz
Operation
RackConsole-LED 17HR · 4