Settings In Practice; Pulse Only" - Wave Simulation - Tunze 7096 Gebrauchsanleitung

Settings in practice

Prior to the initial operation, please ensure a secure attachment of the pumps / Wavebox in the aquarium !
Position the pumps in the aquarium in such a way that the settings on the Multicontroller cannot cause any
water damage due to excessive currents !

„Pulse only" - wave simulation

The pulse operation produces biologically active current pulses (=waves); thus simulating the wash of
waves. The larger the difference is between the performances of the pumps set, the larger the wave
characteristic of the current.
Click the "Pulse only" button in the "Mode" field.
Click „Power 1" and „Power 2" pump outputs in the „Power control" field to set channels 1 to 4. Figure
"0" indicates that the pump is not operational. The lowest possible setting is 30 per cent which can be
increased to 100 per cent.
Set the "Pulse flow" pulse frequency from 0.30 to 8.00 seconds. This pulse frequency is precise and can
also be used as Wavecontroller.
Up to four pumps can be connected directly. By using two branch adapters 7092.34, an extension to a
maximum of eight pumps is possible.
77