Tips And Tricks; Accessories; Repairs - Metabo BS 14.4 LT Impuls Originalbetriebsanleitung

17026913_1209 Akku_Range LT.book Seite 13 Montag, 21. Dezember 2009 1:44 13
8.11 Keyless chuck
AUF, RELEASE
2
GRIP, ZU
Opening the chuck
Turn sleeve (2) in the direction "AUF,
RELEASE".
The grating sound which may be heard after
opening the drill chuck is functional and is
stopped by turning the sleeve (2) in the oppo-
site direction.
Clamping the tool
- Open the keyless chuck and insert the tool as far
as possible.
- Turn sleeve (2) in direction "GRIP, ZU" until the
noticeable mechanical resistance has been over-
come.
- Caution! The tool is not yet clamped! Keep
turning the sleeve (it must "click" when turning)
until it cannot be turned any further - only now is
the tool securely clamped.
Unscrewing the chuck
c 2
- Open the keyless chuck.
- Slacken the screw (a) (note: left-handed thread!).
- Lock the spindle using a spanner (c), loosen and
unscrew the keyless chuck (2) by striking an
inserted Allen key inserted with a rubber
hammer.
Employ the same procedure when attaching the
chuck, except in reverse order.
Cleaning
From time to time, hold the machine vertically with
the chuck facing downwards and turn the sleeve
fully in the direction "GRIP, ZU" and then turn fully
in the direction "AUF, RELEASE". The dust
collected falls from the keyless chuck.

9 Tips and Tricks

Drilling
- Preferably in 2nd gear (high speed).
- Activate the pulse function (depending on the
model) to drill steel, aluminium or tiles without
centre punching or pre-drilling.
- Drill tiles and other brittle materials without
impact (depending on the model).
- In the case of deep bores, pull the drill bit out of
the bore from time to time in order to remove the
drill dust or swarf.
Screws
- Preferably in 1st gear (low speed) and with
torque control.
- Before inserting screws with deformed heads
into wood, activate the pulse function
(depending on the model).
- Activate the pulse function (depending on the
model) to reach the maximum torque while
inserting screws.
- The chuck can be removed for screwdriving.
Insert screwdriver bit directly in the hexagon
socket of the spindle. The screwdriver bit is
retained if a bit clamping bush (accessory, order
no. 6.31281) is fitted.
Thread tapping
- Lubricate the dies.
- Select 1st gear (low speed).
- Adjust torque control.
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
a
See page 4.
A Chargers
B Battery packs with different capacities.
C Clamping ring with bit depot
D Bit clamping bush
For complete range of accessories, see
www.metabo.com or the main catalogue.
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
ENGLISH

10 Accessories

Use battery packs only with voltage suitable
for your power tool.
Slide the clamping ring onto the machine
flange from the front (remove additional
handle (1) if necessary) and push together until
they engage.

11 Repairs

ENG
13