Product Information - Hilti HIT-HY 150 MAX Gebrauchsanweisung

Product Information

– Always keep this instruction together with the product. Ensure that the instruction is with the product even when given
to another person.
– Material Safety Data Sheet: Review the MSDS before use.
– Check Expiration date: See imprint on foil pack manifold (month/year). Do not use expired product.
– Foil pack temperature during usage: between 0 °C and 40 °C / 32 °F and 104 °F.
– Base material temperature during installation: between -10 °C and 40 °C / 14 °F and 104 °F.
– Conditions for transport and storage: Keep in a cool, dry and dark place between +5 °C and 25 °C / 41 °F and 77 °F.
– For any application not covered by this document / beyond values specifi ed, please contact Hilti.
– Partly used foil packs must be used up within 4 weeks. Leave the mixer attached on the foil pack manifold and store
under the recommended storage conditions. If reused, attach a new mixer and discard the initial quantity of anchor
adhesive.
WARNING
! Improper handling may cause mortar splashes.
– Wear tightly sealed safety glasses, gloves and protective clothes before handling the mortar!
– Never start dispensing without a mixer properly screwed on.
– Attach a new mixer prior to dispensing a new foil pack (snug fi t).
– Use only the type of mixer supplied with the adhesive. Do not modify the mixer in any way.
– Never use damaged foil packs and/or damaged or unclean foil pack holders.
! Poor load values / potential failure of fastening points due to inadequate borehole cleaning. The boreholes must be free
of debris, dust, water, ice, oil, grease and other contaminants prior to adhesive injection.
– For blowing out the borehole - blow out with oil free air until return air stream is free of noticeable dust.
– For fl ushing the borehole - fl ush with water line pressure until water runs clear.
! Ensure that boreholes are fi lled from the back of the boreholes without forming air voids.
– If necessary, use the accessories / extensions to reach the back of the borehole.
– For overhead applications use the overhead accessories HIT-SZ and take special care when inserting
the fastening element. Excess adhesive may be forced out of the borehole. Make sure that no mortar
drips onto the installer.
Printed: 07.04.2017 | Doc-Nr: PUB / 5076327 / 000 / 06 Printed: 07.04.2017 | Doc-Nr: PUB / 5076327 / 000 / 05 Printed: 08.07.2013 | Doc-Nr: PUB / 5076327 / 000 / 04
Hilti HIT-HY 150 MAX
23
en
de
pl
cs
sk
sv
da
ru
fi
no
bg
ro
hu
hr
sl
et
lv
lt