Setting The Clock; Using The Alarm - LEXIBOOK MeteoClock Precious Quattro Bedienungsanleitung

SM840IM size : 90mm W x 150mm H

SETTING THE CLOCK

To set the calendar and the clock
1. Press the SET button.
2. Use the + and – keys to set the year. Press SET to confirm.
3. Use the + and – keys to set the date (Day/Month). Keep the + or - key
pressed to adjust the digits at a faster rate.
Note: to set the month, you must add up the number of days until you
reach the correct date.
4. Press SET to confirm.
5. Use the + and – keys to set the current time. Keep the + or - key
pressed to adjust the digits at a faster rate. Press SET to confirm.
6. Press the +/- keys to select 12H (AM/PM) or 24H time display format.
7. Press SET to confirm.

USING THE ALARM

To use the daily alarm
1. In standby mode (normal display), press the +/- keys to set the alarm
time. Keep the + or - key pressed to adjust the digits at a faster rate.
2. Slide the SNZ/ON/OFF/ALM switch to the ON position. The
be shown above time display.
3. When the alarm rings, press any button on the facing of the unit or the
SNOOZE/LIGHT button located on top the unit to stop the alarm. It will
ring again the next day at the time set.
To use the snooze function
1. In standby mode (normal display), press the +/- keys to set the alarm
time. Keep the + or - key pressed to adjust the digits at a faster rate.
2. Slide the SNZ/ON/OFF/ALM switch to the SNZ position. The
will be shown above the alarm time display.
3. When the alarm rings, press any button on the facing of the unit or the
SNOOZE/LIGHT button located on top the unit to snooze the alarm
again. The alarm will ring 5 minutes later.
4. To turn off the snooze alarm, slide the SNZ/ON/OFF/ALM switch to the
OFF position.
To deactivate the alarm
Slide the SNZ/ON/OFF/ALM switch to the OFF position. The
disappear from the display.
icon will
icon
icon will
9
WEATHER DISPLAY
Indoor temperature and pressure display
Press the UNITS key to select the display units of the indoor temperature
and pressure (ºC and hPA or ºF and InHg).
Weather report symbols
This weather station is able to detect barometric pressure changes, and
based on the data collected, can predict the weather for the next 12 to 24
hours.
Sunny Partly Cloudy Cloudy Rainy
REMARKS:
• After having completed the settings of your weather station, please
discard the readings of the weather forecast for the next 12-24 hours.
This will allow sufficient time for the Weather Station to operate at a
constant altitude and therefore result in a more accurate forecast.
• Absolute accuracy cannot be guaranteed regarding weather forecasting.
The weather forecasting feature is estimated to have an accuracy level of
about 75% due to the varying areas the Weather Station has been
designed to be used in.
You may need to reset the unit in the following cases:
- If the weather station is moved to another location significantly higher or
lower than its initial standing point. By doing this, the weather station will
mistakenly consider the new location as a possible change in air pressure.
- If the weather icon does not display the correct weather forecast for an
extended period of time.
To reset the unit, use a blunt object (the tip of a paper clip for example) to
press the RESET key located on the bottom front part of the unit. Again,
discard the weather forecasts for the next 12-24 hours as to allow time for
operation at a constant altitude.
ATMOSPHERIC PRESSURE DISPLAY
Pressure trend
The trend pointer indicates the trend of the barometric
pressure.
The upper arrow indicates that the barometric pressure
trend is increasing.
The lower arrow indicates that the barometric pressure
trend is decreasing.
10
Heavy Rain