Specifications - Oursson JM3308 Bedienungsanleitung

CLEANING AND MAINTENANCE, Рiс. С
• Pulp container, filter insertion, mesh filter, lid and pusher
can be washed in the dishwasher. Thoroughly dry all
parts.
Wipe the device with a damp cloth. Never immerse
the device into the water because of the risk of
electric shock.
POSSIBLE PROBLEMS AND SOLUTIONS
Solutions
Problem
• Check whether the power cord is connected to the outlet. If the device is not connected, plug it to the
outlet.
Device does not
• Check whether the device is assembled correctly. If not, disassemble and reassemble according to the
work
instructions.
• If the problem persists, contact an authorized service center OURSSON.
• The various ingredients have different moisture contents.
• If the products are not fresh, they lost their juiciness. Put the ingredients in water for 1-2 hours
to recover.
Little juice
• If you are using ingredients with small seeds, then after few loads their presence can reduce the
amount of juice. For best results, between preparations disassemble the machine and clean it
from seeds.
• With continued juicing and depending on the ingredients, juice may contain much pulp.
• To reduce the pulp in the juice, disassemble the juice cup and remove the pulp more often.
• If the filter or screw is damaged - it can affect the performance and quality of juice. It is
A lot of pulp in the
recommended to replace them
juice
• If too much of the ingredients are loaded into the juice maker simultaneously, this can lead to
frequent stoppages and to a large number of pulp in the juice. Place ingredients slowly and in
small portions.
• Make sure that all parts are correctly assembled. Try to disassemble and assemble the juice
maker again and listen to the noise.
• Do not turn the juice maker without ingredients.
Extraneous
• Check the size of the juicing products. It is recommended to cut large ingredients into small
sounds when the
pieces so the fit into the feeding chute.
device is working
• Depending on the type or size of various ingredients different noises may occur.
• Noise may occur when the juice maker is working on uneven or inclined surfaces. Lace it on a
flat stable surface.
• At the beginning of juicing, the pulp can be wet.
• The recovered pulp can be wet if you are using stale ingredients.
Pulp is very wet
• Before juicing ingredients stored in the refrigerator for a long time, put them in clean drinking
water for 1-2 hours.
The device is
• A small vibration of juice maker is allowed during operation. It is not considered a malfunction.
vibrating
The device has
• Turn off the device and let it cool for 5 minutes. Then turn it on again.
stopped working
PRODUCT CERTIFICATION
For information on product certification, see http://www.oursson.com or ask seller for a copy.

Specifications

Model
Power consumption, W
Rated voltage
Protection class
Storage and transportation temperature requirements
Operation temperature requirements
Humidity requirements
Weight, kg
*Products should be stored in dry, ventilated warehouses at temperatures below - 25°C.
NOTE: Colored scurf on plastic parts of the juice maker,
for example from the carrot juice or beet juice can be
removed with a little vegetable oil. Than wash the parts
under the running water.
JM 3308
max 800
220-240 V~; 50 Hz
II
-25 °C to +35 °C
+5 °C to +35 °C
15-75% (without condensation)
7,3
13