Blade Adjustment; Clutch Adjustment - Wolf Garten Exclusiv 40 TA Gebrauchsanweisung

8 ADJUSTMENTS
8.3 CYLINDER TO BOTTOM BLADE ADJUSTMENT __________________________
The cutting cylinder must be set to engage correctly with
the bottom blade. To check: Tilt the machine backward,
hold a thin piece of paper between the edge of the blade
and spiral cutters. Turn the cutting cylinder manually.
The paper must be cut equally along the length of the
bottom blade. To adjust: Set the bottom blade by turning
adjusters (A). DO NOT OVER TIGHTEN - the cutting
cylinder must turn freely.
Adjustment is made by turning the adjustment screws (A)
to the right side to move the cylinder toward the blade.
It is recommended that an eighth of a turn is made to each screw, check after each of these adjustments until the
correct setting is reached.
8.4 CYLINDER CLUTCH ADJUSTMENT ____________________________________
The adjustment of the cylinder clutch is made with the
clutch in the engaged position. Loosen the two locknuts (A).
Turn the adjuster until the correct adjustment is made.
Tighten the locknuts. When the adjustment is correct, the
clutch dogs will engage and disengage completely as the
clutch lever is operated.
en-40
WARNING
Turn petrol tap to the "OFF" position before you
tilt the machine.
A
A
A
B
C