Inhaltsverzeichnis
Werbung
LAUDA Immersion Coolers
ETK 30, ETK 50
1
Brief operating instruction
Check if the immersion cooler has sustained damage. If necessary inform the forwarding
agent or post office.
Set up the instrument according to section 4.
Compare the voltage and the frequency mentioned on the rating label with your network.
Put in the power supply plug.
1.1 Starting up
Immerse the cooling coil into the consuming device concerned.
Maximum cooling capacity is only obtained with completely immersed cooling coil.
During operation the bending radius must not be smaller than 150mm
ETK 50: Adjust the desired temperature. ETK 30 has no temperature control.
Switch on the instrument at the mains switch (green lamp goes on).
ETK 50: If the thermostating liquid has obtained the desired value the control device
operates. Pilot lamp "Cooling" goes on and out.
ETK 30: Cools down to ist lowest temperature.
YAFE0002/04.07.03
- 4 -
Werbung
Inhaltsverzeichnis
