Items Supplied; Proper Use; Important Notes - EINHELL 44.192.53 Bedienungsanleitung

Anleitung BT-US 400_SPK1:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Layout
1. On/Off switch
2. Rubber feet
3. Thumb screw
4. Angle scale
5. Base
6. Sanding/grinding section
7. Cross stop
8. Leg support
9. Sanding/grinding belt clamp
10. Knurled screw for sanding/grinding belt
adjustment
11. Sanding/grinding belt
12. Stop rail
13. Sanding/grinding disk
14. Sanding/grinding table
15. Lock screw for sanding/grinding table
16. Plastic guard

2. Items supplied

Belt and disk sander/grinder
Sanding/grinding disk
Adhesive sanding/grinding disks
Sanding/grinding belt
Socket-wrench

3. Proper use

The belt and disk sander/grinder is designed for
sanding/grinding all types of timber, commensurate
with the size of the machine.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting such cases of misuse.
The machine is to be operated only with suitable
09.01.2008 16:26 Uhr Seite 11
sanding/grinding belts which comply with the
specifications contained in these operating
instructions.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Harmful emissions of wood dust when the
machine is used in closed rooms.
For functional reasons the rotating parts in the
device cannot be covered. It is therefore
imperative that you proceed with caution and
hold the workpiece firmly to prevent slippage, as
this may result in your hands coming into contact
with the sanding/grinding belt.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Important notes

Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.
Safety regulations
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
GB
11