The Le D - D Is Pl A Y - SOLIS 7214 Bedienungsanleitung

THE LE D - D IS PL A Y

▲ ▲
These symbols indicate:
ing the button once will increase time by one hour. The display will state the 1, 2, 4
or 5 hours. Adding up these illuminated numbers will allow you to read off the
set time.
Set air humidification capacity (cold mist).
3 settings can be selected
Indicates the user programmed resp. current air humidity. While
programming the air humidity that is to be reached resp. maintained in the
room, the display will flash. A few seconds after the last setting has been made,
the display will illuminate permanently and display the current air humidity.
Empty water tank display.
Auto function is enabled.
Lowest warm mist level is set.
Intermediate warm mist level is set.
Highest warm mist level is set.
Warning prompt for excessive temperature which has activated
High temp.
overheating protection. Should case the humidifier be damaged or
wrongly operated, the heating or nebulisation units might overheat,
causing the machine to switch off automatically - the prompt „High
temp." will illuminate as a warning symbol. In this case, turn off the
machine, pull the power plug and remove the water tank. Empty
out the water in the nebulisation chamber (be careful, as this water
might be hot). Completely fill up the water tank with fresh, luke-
warm water (10 °C–40 °C) and place it back onto the appliance. Plug
the power plug back into the outlet and turn the machine back on.
Set humidity
Programming mode for air humidity is activated.
62
Time set using the timer button. Operation
time can be set between 1 and 12 hours, press-