Machine-Specific Safety Instructions - Collomix Xo 1 Originalbetriebsanleitungc

Machine-specific safety instructions


WARNING
: Read all notes and instruc-
tions on safety. Failure to observe any of the notes
and instructions on safety may result in an electric
shock, fire and/or serious injury.
Make sure that you keep all notes and instructions
on safety for future reference.
To be able to use the machine safely it is essential
that you read the operating instructions and the
safety instructions thoroughly and comply with all of
them. The machine is to be used only by persons
who have read the operating instructions and who
are acquainted with the occupational safety and
accident prevention regulations in force in your
country.

In addition, you must also comply with the
general safety instructions also included with the
machine.
►Take care to ensure that the mains power supply
corresponds to the specifications on the rating plate.
►Do not use the device in any environments with
potentially explosive atmospheres. Do not mix any
readily flammable solvents or solvent-containing
substances with a flash point of below 21° C.
►Take care to ensure that no liquid splashes
against the motor housing and keep it away from
the rain – risk of electric shock!
►Never clean the machine with water – risk of
electric shock!
►Do not wind cables or leads around any parts of
your body.
►Do not use the machine with a damaged cable.
Do not touch the cable and pull out the power plug
immediately. There is an increased risk of electric
shock from damaged cables. If the mains power
cable has to be replaced (because of damage
or similar), ensure that it is replaced by the
manufacturer or an authorized representative of the
manufacturer (electrician) in order to avoid any risk
to safety.
►Always hold the machine firmly with both hands
when carrying out your work and make sure you
have a secure footing.
►Hold the machine by the insulated grip surfaces
when carrying out work where it may be possible for
the plug-in tool to come into contact with concealed
power cables or the machine's own mains power
cable. Contact with a live cable may make metal
components of the machine live as well and could
cause an electric shock.
►Before starting up, check that the mixing rod is
securely attached and rotates without a hitch.
►Start up and run down the machine in the mixing
container only. Ensure that the mixing container is
stood in a firm and secure position.
►Do not reach into the mixing container with your
hands or insert any other objects into it while mixing
is in progress. Risk of crushing!
►Wait until the machine or tool comes to a complete
standstill. Rotating tools can snag and cause injuries
or damage.
►If the sound pressure level should exceed 85 dB
(A) where you are working, use ear protection!
►We recommend that you wear work gloves and
protective goggles when using the mixer. Regulations
require that you wear close-fitting clothing.
►To protect yourself from harmful dust while mixing,
wear a dust mask. Some mineral materials are
deemed to be carcinogenic. Use a dust extractor
wherever possible.
► Always connect machines via a residual current
device (RCD) with a rated residual current of 30 mA
or less.
Read and observe the operating
instructions for the machine before
you start it up!
Always wear protective goggles and
ear protection while working.
It is advisable to wear a dust mask
whenever working with materials
which generate large amounts of
dust.
Always wear protective gloves while
working.
EN