Gastroback 42639 Bedienungsanleitung Seite 34

• During operation keep the appliance in an appropriate distance of at
least 20 cm on each side to the edge of the working space and furni-
ture, walls, boards, curtains. Leave at least 50 cm of free space above
the appliance. Exclusively use the appliance for domestic use and for
grinding roasted coffee beans. The appliance is not suited for chopping
or grinding other foodstuffs. Immediately unplug the appliance, if there is
any kind of malfunction or problem (e.g. the motor gets stuck, overhea-
ting). Do not operate the appliance continuously for more than 2 minutes.
After this period of operation make a break of at least 20 minutes.
• This appliance is NOT intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children must always be supervised to ensure that they
do not play with the appliance or any parts of the appliance or the
packaging. Always keep the appliance where it is dry, frost-free, and
clean, and where young children cannot reach it. Do not leave the
appliance or any part of it unattended, when in reach of young children.
• Do not place the appliance or any part of it on or near hot surfaces (e.g.
burner, heater or oven). Do not use any parts of the appliance with any
other device or for any other purpose. Before operation, always ensure
that the appliance is assembled completely and correctly according to
the instructions in this booklet. Do not handle the appliance or any part
of it with violence.
• Do not insert your fingers or any foreign objects (e.g. clothes, cooking
utensils) in the bean hopper or milling works, with the appliance con-
nected to the power supply. Do not use any hard, sharp or edged objects
(e.g. knives, forks, cleaning brush) with the appliance.
• It is best to close the bean hopper lid securely before operation. Do not
open the bean hopper lid during operation.
• Do not leave the appliance unattended, when it is connected
to the power supply. Always switch off (with the milling works run-
ning: press the START | PAUSE | CANCEL button) then unplug the
appliance, before moving, or cleaning the appliance, or assem-
34