Connection Diagrams; Install The Hardware - Axis P1204 Installationsanleitung

Connection Diagrams

I/O Connector
1
0 V DC (-)
2
DC output 3.3 V, max 50 mA
3
Digital input 0 to max 40 V DC
4
Digital output 0 to max 40 V DC, open drain, 100 mA

Install the Hardware

Important
The casing of the main unit is not approved for outdoor use - the product may only be
installed in indoor environments.
Make a note of the serial number (S/N) located on the product label. This number may be required
during installation.
The main unit can be mounted on a DIN rail or using the supplied mounting rail.
1. If using the mounting rail, fasten it with screws to the wall or ceiling, using screws and
plugs appropriate for the wall/ceiling material. Note the direction of the two tabs on the
rail, the tabs align with the upper side of the main unit.
AXIS P12 Network Camera Series
17