Axis P1204 Installationsanleitung Seite 22

AXIS P12 Network Camera Series
• Drill a hole with 20mm diameter in the wall, either completely through the material, or
use a countersink cutter to have a smaller opening.
• Pull off the protection on the adhesive and attach the mounting bracket to the wall.
Optionally secure the bracket with two screws through the holes.
• Insert the camera and tighten the lock ring as shown in the image below. Position the
camera so that the flat surface on the thread is vertical or horizontal.
• Proceed to Connect the cables, see Connect the Cables on page 24.
22