Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AXIS Q1635 Network Camera
How to install the product
Install the Hardware
NO
NO TICE
NO
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
1. Optionally connect external input/output devices, such as alarm devices. See for
information on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
-
PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
-
Connect an external power adapter to the power connector block. See
Connectors.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page
16 for more details. Note that the Status LED can be configured to be unlit during
normal operation.
6. Optionally insert a microSD card (not included) into the SD card slot.
NO
NO TICE
NO
TICE
TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
How to access the product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/support
The product can be used with most operating systems and browsers. We recommend the following
browsers:
•
Internet Explorer
®
•
Safari
with OS X
TM
•
Chrome
or Firefox
For more information about using the product, see the User Manual available at www.axis.com
®
®
with Windows
®
®
with other operating systems.
10
Werbung
Inhaltsverzeichnis
