How To Install The Product; Recommended Tools; Install The Hardware; Wall Mount - Axis Communications V59 Serie Installationsanleitung

How to install the product

Recommended tools

• Drill – if using the wall or drop ceiling mount

Install the hardware

There are three ways to install the camera:
NO TICE TICE
NO NO TICE
The camera shall be installed upright or upside down, never sideways or at an angle.
• Standing on a table top.
• Hanging on a wall, see Wall Mount on page 9
• Hanging from a drop ceiling, see Drop Ceiling Mount on page 10
To install the camera on a table top:
1. Place the camera on a table top or other horizontal surface. Make sure that the surface
is stable.
2. Insert the SD memory card (optional).
3. Connect the required cables to the camera.
NO TICE TICE
NO NO TICE
Be careful not to stretch or bend the cables too much. This could cause damage to the
cables.
4. Connect the power supply to a mains power outlet (100–240 VAC).

Wall Mount

WARNING
The combined weight of the camera and mounting bracket is approximately 1.7 kg (3.7 lb.).
Make sure that the wall material is strong enough to support this weight.
1. If required, route the cabels through the wall.
2. Install the mounting bracket on a wall and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
3. Insert the SD memory card (optional).
4. Mount the camera on the mounting bracket and tighten the tripod screw. Alternatively
use the Outer mounting hole to allow for more cable to fit behind the camera.
AXIS V59 Series
9
EN