Axis Communications Q1635 Installationsanleitung Seite 18

AXIS Q1635 Network Camera
Buttons
Control Button
For location of the control button, see .
The control button is used for:
• Resetting the product to factory default settings. See page 14.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
Function button
The function button has multiple functions:
• Leveling assistant – This function helps to ensure the camera is level. Press the button
for about 3 seconds to start the leveling assistant and press again to stop the leveling
assistant. The status LED and buzzer signal assist leveling of the camera, see Status LED
behavior and buzzer signal for leveling assistant on page 17. The camera is level when
the buzzer beeps continuously.
• Focus assistant – This function is used for enabling the focus assistant. To enable the
focus assistant, press and very quickly release the button. Press again to stop the focus
assistant.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic compatibility (EMC) 4.
Audio connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
18