Leister HOTWIND SYSTEM Bedienungsanleitung Seite 25

HOTWIND SYSTEM configuration and operation
Establish power supply
cord (1) to the electrical
mains.
Function button (2)
Press for 3 seconds-
Set up menu
Function button (2)
1 × short press
L e g e n d
Display
(Air)
(°C)
(Closed Loop) Regulated
(Connector)
(°F)
(Heater)
(Loop)
(Open Loop)
(Pot)
(Setup)
(Unit)
If in the set up menu the function button (2)
is not pressed for 10 seconds, the unit
automatically switches to stand by
Stand by
Description
Set point value –
air volume
Celsius
Interface
Fahrenheit
Set point value –
heating
Control
Controlled
Potentiometer
Configuration
Unit
Function button (2)
ON
Function button (2)
Press for 3 seconds
°C
Function button (2)
1 × short press
Function button (2))
1 × short press
Function button (2)
1 × short press
°C
Function button (2)
1 × short press
Heating
Cool Down
Function button (2)
Press for 3 seconds
Function button (2)
Press for 3 seconds
Function button (2)
Press for 3 seconds
Function button (2)
Press for 3 seconds
°F
25