Device Description - Leister HOTWIND SYSTEM Bedienungsanleitung

Device Description

10
12
11
2
1
HOTWIND PREMIUM or SYSTEM
1 Power supply cord
2 Main switch with function button
3 Potentiometer for temperature (red)
4 Potentiometer for air volume (blue)
5 Heating element tube
6 Air inlet flange for stainless steel filter
7 Holder for handle
8 Four fastening screws
9 Three M5 thread inserts for fastening
for installation
Function of heating element and device protection
• If the heating element or device overheats (too hot inlet air or excess heat reside), the power supply to the
heating element will be interrupted and the working contact of the alarm relay opened.
If the heating element or device protection responds, it will be necessary to reset the HOTWIND for reasons
of safety. This occurs by pressing the function button (2)
installation).
Adjustable potentiometer
• The internal electronics regulates the maximum outlet air temperature to 650 °C.
• The reference values can be deviated from due to ambient conditions and component tolerances.
Potentiometer
Position
Heating power %
Air volume l/min
Temperature (3680 W)
at 300 l/min °C
20
7
3
4
0
10
0
10
1
9
1
9
2
8
2
8
3
7
3
7
4
6
4
6 5
5
0 1
OFF 10
200 270
Environment 90
13
6
HOTWIND SYSTEM
10 Display
11 Alarm contact
12 Interface
HOTWIND PREMIUM hand device or SYSTEM
13 Handle
14 Protective tube
2 3 4
20 30 40
340 410 480 550
150 215 275 340
9
for three seconds. Check inlet air (see
5 6 7 8
50 60 70 80
620 690 760
400 465 525
14
9 10
90 100
830 900
590 650