Inhaltsverzeichnis
Werbung
Parameters
FM Depth
Range: -64 — +63
This determines the amount of modulation created by the FM function. Higher values result in greater
modulation depth.
VCO Detune
Range: -64 — +63
This determines the amount of pitch difference between VCO1 and VCO2.
VCO1 Edge
Range: -64 — +63
This determines the sharpness or smoothness of
the edge of the VCO1 waveform. Higher (positive)
values produce a sharper wave, resulting in a
harsher sound. Lower (negative) values produce a
rounder wave, resulting in a softer sound. A value
of "-64" results in a sine wave.
VCO1 PW (Pulse Width)
Range: -64 — 0 — +63
This determines the width of the VCO1 pulse wave. Higher (positive) values produce more harmonics,
resulting in a fatter sound. In general, pulse width is used to control the pulse wave; however, the
PLG150-AN can use PW with other waves as well, for a wider possible variety of sounds than usual.
30
This parameter differs from that in FM Synthesis (such as used by DX-series synthesizers). Too
deep of a setting will change the pitch of the voice.
Depending on the selected voice, this parameter may not be changeable ("
display).
When Pulse
Width is small...
...the sound has
...the sound is that of typical
many harmonics.
Sharp-edged
waveform
When the Pulse
Width is set to "64" (50%)...
pulse wave, with only
odd-numbered harmonics.
****
" appears in the
Slightly rounded
Sine wave
edges
When Pulse
Width is large...
...the sound has
many harmonics.
Werbung
Inhaltsverzeichnis
