Symbols On The Device; Proper Use; Environmental Protection - Kärcher BC 1/1.8 Originalbetriebsanleitung

Symbols on the device

Protect the charger against moisture
–
and store it dry. The device is only suit-
able for use in rooms; do not expose the
device to rain.

Proper use

The charger is suitable for charging the fol-
lowing battery packs with nominal voltage
of 3.6 V to 28.8 V:
V Ah
7,2 NiCd 1,5
7,2 Li-Ion 1,3
7,2 Li-Ion 2,6
25,2 Li-Ion 3,3
25,2 Li-Ion 3,3
25,2 Li-Ion 4,5

Environmental protection

The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for disposal, but
arrange for the proper recycling.
Old appliances contain valuable ma-
terials that can be recycled; these
should be sent for recycling. Batteries
and accumulators contain substances that
must not enter the environment. Please
dispose off old devices, batteries and re-
chargeable batteries through suitable
waste collection systems.
min
50 -186.0
58 -257.0
93 -273.0
115 -183.0
115 -255.0
160 -284.0
EN
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH
Operation
Note
New battery packs reach their full capacity
after approx. 5 charging and discharging
cycles.
Recharge battery packs again if they have
not been used for a long time.
The performance of the battery pack reduc-
es when temperature falls below –10 °C.
Storage for a long time at temperatures
above 40 °C can reduce the capacity of a
battery pack.
 Insert the mains plug into the socket.
The device conducts a self-test. Both
–
the LEDs glow for 1 second. The de-
vice then goes into the stand-by mode:
both LEDs get switched off.
 Slide the batter pack on the battery
holder of the charger.
The battery pack will be charged auto-
–
matically; the green LED blinks.
If the battery pack is too hot or too cold,
–
the red LED glows. The charging pro-
cess starts when the battery pack has
reached the correct charging tempera-
ture (5 °C ... 45 °C).
When the battery pack is fully charged,
–
the green LED glows. The charger au-
tomatically switches to retention charg-
ing.
 Remove the battery pack and insert it in
the device.
Note
The charged battery pack can remain on
the charger till it is to be used. There is no
risk of over-charging.
– 2
7