Set Pause Time; Set Dtmf Or Pulse Mode; Reset Complete Device Back To Factory Settings - TIPTEL 140 Bedienungsanleitung

Set Pause Time

Go off-hook. Press and hold
short press / P and the pause time ( 1 for 1.2 seconds, 2 for 2.4 seconds or 3
for 3.6 seconds) required by your network or PABX. Press
setting (LED indicator stops flashing).
The default pause time is set to 2.4 seconds. Dialing out, the device will create a
pause of the selected length after dialing the digits stored in EXT. NO. (see: Set Ext.
No.). This pause time will be used when pressing P or using the speed dial
memories accordingly.

Set DTMF or Pulse Mode

The phone comes with tone dialing (DTMF) as default setting.
To change, go off-hook using
short beep. Go on-hook again using
Pulse Mode. It is possible to temporarely switch from pulse to DTMF mode during a
call pressing * .
Go off-hook using
Go on-hook again using
dialing) Mode once again.
Please, ask your network provider or PBX installer (in case this device is used
behind a PBX) for the appropriate setting.

Reset complete device back to factory settings

In on-hook mode, press
continously. This clears all memory and all settings. The device is back to initial
factory setting after some seconds.
Setup
for 3 seconds (LED indicator starts flashing), then
. Press # for about 8 seconds until you hear a
. From now on any further dialing will be in
. Press * for about 8 seconds until you hear a short beep.
. From now on any further dialing will be in DTMF (tone
until the weekly flickering LED indicator lights up
11
to confirm the
e
n
g