Function Setup; Ext. No. (Co-Line Access); Set The Ring Melodies; Set The Ring Volume - TIPTEL 140 Bedienungsanleitung

Function setup

Ext. No. (CO-line access)

Store
Go off-hook. Press and hold
short press # and the Ext.No. (digits for CO-line access) required by your PABX.
Press
Delete
Go off-hook. Press and hold
short press # .Press
When the phone is operated behind a PBX, Ext. No. can be set for dialing outside
phone numbers and a pause will be added automatically between the Ext. No. and
the phone number you dialed. Ex.: If you set up the Ext. No. as 0 and dial from the
phone book, the number stored as 0021024280 will be practically dialed as 0,
pause, 021024280 (see: Set Pause Time).
e
n

Set the Ring Melodies

g
In on-hook mode, press and hold
Short press

Set the Ring Volume

In on-hook mode, press and hold
setting. Short press

Set Flash Time

Go off-hook. Press and hold
short press R and the flash time (100, 200, 300, 400, 600 or 900) required by your
network or PABX. Press
Please, ask your network provider or PBX installer (in case this device is used
behind a PBX) for the appropriate setting.
to confirm the setting (LED indicator stops flashing).
to confirm the setting (LED indicator stops flashing).
several times to select the melody you like.
or several times to adjust the volume.
to confirm the setting (LED indicator stops flashing).
Setup
for 3 seconds (LED indicator starts flashing), then
for 3 seconds (LED indicator starts flashing), then
for 3 seconds to enter ring melody setting.
or for 3 seconds to enter ring volume
for 3 seconds (LED indicator starts flashing), then
10