Using The Seat Heater; Guarantee - Waeco MagicComfort MSH50 Montage- Und Bedienungsanleitung

_MSH50_MSH501.book Seite 25 Donnerstag, 13. August 2009 2:48 14
MagicComfort MSH50, MSH501
Electrical connection
The seat heater MagicComfort MSH50 has one switch each for the driver's and
passenger seats, the seat heater MagicComfort MSH501 only one for the seat
chosen.
The complete circuit diagram can be found in fig. h, page 6.
Caution
a
Ensure it has been securely fitted, particularly in the area of the
seat rails.
Find a suitable place for installing the seat heater switch.
If possible, use the blanking plugs provided for this purpose.
Ensure that there is enough room behind the panel for the installation of
the switch.
Mark the switch cut-out using the template provided (fig. g, page 5).
Cut out the marked area with an appropriate tool.
Install the switch into the cut-out (fig. d, page 5).
Install the ready-made wiring harness so that the cables cannot bend or
fray (fig. e, page 5).
7

Using the seat heater

Switch the seat heater on using the corresponding switch (level I or
level II).
To switch the seat heater off: Turn the corresponding switch to position 0.
8

Guarantee

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
Using the seat heater
25