Hama 00040072 Bedienungsanleitung Seite 4

G Operating instruction
Universal Remote Control
Thank you for your decision for a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
Function buttons
1. ON/OFF / LED Indicator
2. Device selection keys
3. Vol +/- Volume settings
4. Mute
5. Number keys 0-9
6. -/-- switch to two-digit channel numbers
7. Setup – Remote control settings
8. Menu – to enter On-screen menu
9. AV – Select external AV source
10. To confirm a selection
11. Exit – to exit on-screen Menu
12. CH +/- - Channel Selection
1. Explanation of the Note symbol
Note
► This symbol is used to indicate additional
information or important notes.
2. Package Contents
- Universal Remote Control (URC)
- Code List
- This operating instructions
3. Safety notes
• Do not use the Universal Remote Control in mo-
ist or wet environments and avoid spray-water
contact.
• Do not expose the Universal Remote Control to
heat sources or direct sunlight.
• Do not drop the Universal Remote Control.
• Never open the Universal Remote Control.
It contains no user-serviceable parts.
• As with all electrical devices, keep the Universal
Remote Control away from children.
2
4. Getting started – installing the Batteries
Note
► Alkaline batteries
Use 2 „AA" (LR 6/Mignon) type batteries.
► Remove the battery compartment lid on the
back of your URC (A).
► Check the required battery polarity and in-
sert batteries according to the "+/–" marks
inside the compartment (B).
► Close battery compartment lid (C).
Note: Code saver
► This remote control saves the settings during
battery change.
Note: Battery saving function
► The remote control switches off automatically
when a button is pressed down for more than
15 seconds. This conserves battery power if
the remote control gets stuck in a position
where the buttons are continually pressed
down, such as between sofa cushions.
5. Setup
Note
► To obtain a proper infrared (IR) transmission,
allways point your Remote control in the
approximate direction of the device you
want to control.
► No entry for approx. 30 seconds will time out
the Setup mode. The LED indicator shows six
flashes and turns off.
are recommended.