Check Before Starting; Electrical Connection; Electrical Safety - Husqvarna TS 100R Bedienungsanleitung

Check before starting

Please read the instructions for use prior to op-
erating the machine for the first time.
Motor off.
The working area must be completely
cleared, well lit and all safety hazards
removed (no water or dangerous ob-
jects in the vicinity).
The operator must wear protective
clothing appropriate to the work he
is doing. We recommend that this in-
cludes both eye and ear protection.
The use of ear protection is mandatory.
Any persons not involved in the work should
leave the working area.
Use only blades marked with a maximum oper-
ating speed greater than blade shaft speed.
Fitting the disc
Disconnect the machine by unplugging the sup-
ply cable.
• Release the two knobs (23), remove them and then
remove the guard.(12b)
• Unscrew the disk clamping nut (A) using a 30 mm span-
ner. (7)
!
The disc locking nut has a left-hand thread.
• Remove the clamping plate (B) and fit the disk.
Take care about the direction of rotation which
!
is shown by an arrow on one of the faces.
Make sure the contact faces of flanges, of blade
and the axle are clean.
• Check the disk position on the centring plate (C).
• Refit the clamping plate (B) and tighten the nut(A).
• Replace the guard, tighten the knobs (23).
16
- English
Operator's manual - TS 100 R
STOP
!

Electrical connection

Electrical safety

Operate this machine only on a supply
equipped with a 30 mA earthed current-limiting
circuit-breaker. Otherwise, consult our cata-
logue for appropriate models.
The RCCB must be used correctly, including testing it
regularly. For tools supplied with an integral RCCB in the
cable or in the mains plug, if the cable or plug has been
damaged, repairs must be carried out by the manufac-
turer, one of his agents or by a qualified repair workshop
to avoid any risks resulting from errors.
Engines :
- Standard : with on-off switch with no-volt release switch
- 1-phase, 230 V, 2-3 hp 3 x 1,5 mm
- 3-phase, 400 V, 3-4 hp 4 or 5 x 1,5 mm
(cable 3P+E)
- Optional : with cut-out switch with or without ammeter
- 1-phase, 110 V, 2 hp 3 x 2,5 mm
- Make sure that the mains voltage corresponds
=
with that marked on the manufacturer's plate
?
on the machine.
Three-phase motor
Make sure that the motor rotates in the same direction
as the arrow stamped on the casing: if the motor does
not turn in the direction required, swap two of the supply
wires.
Use the following types of plug, single phase
2 P + E, or 3xPx+xE / 3xPx+xNx+xE according
to the corresponding voltage.
- Extension lead: Cable size sufficient for the electrical
power, connection to the mains by a H07 RNF type cable
of the following size:
• 3 x 2.5 mm2 up to 50 m for 230 V
• 4 or 5 x 1.5 mm2 up to 100 m for 400 V
• 3 x 4 mm2 up to 40 m for 115 V
Starting up
Always take care. Get into a comfortable, bal-
anced position.
Remove all adjustment tools and wrenches
from floor and machine
Always keep blade guard in place
with plug (cable 2 P + E)
2
without plug
2
without plug
2