EINHELL 4007250 Bedienungsanleitung Seite 11

Anleitung Euro 8-24 17.01.2006
Read this manual carefully before putting the compressor into operation!
Technical data
Power supply
Motor rating in kW/h.p.
Compressor speed in rpm
Operating pressure in bar
Pressure vessel volume in litre
Theoretical intake rate in l/min.
Sound power level LWA in dB(A)
Sound pressure level LPA in dB(A)
Protection type
Machine weight in kg
Points to note when Safety instructions for
setting up the working with
compressor compressed air and
paint sprayers
G Examine the machine for signs
of transit damage. Report any
Important! Note the pertinent
damage immediately to the
accident prevent regulations in
company which delivered the
force in your area!
compressor.
G Before you put the compressor
Compressors and lines reach
into operation, check the oil
high temperatures during
level in the compressor pump.
operation. Avoid contact! Risk of
G The compressor should be set
burns!
up near the working consumer.
G Avoid long air lines and long
Gases or vapours drawn in by the
supply lines (extensions).
compressor have to be kept free
G Make sure the intake air is dry
of constituents that may cause
and dust-free.
fire or explosions inside the
G Do not set up the compressor
compressor.
in damp or wet rooms.
G The compressor may only be
When you disconnect the hose
used in suitable rooms (with
coupling, hold the coupling
good ventilation and an
element in your hand to prevent
ambient temperature from +5°
injury from the whiplashing hose.
to +40°C). There must be no
dust, acids, vapors, explosive
Wear goggles when working with
gases or inflammable gases in
the blow-out gun. Injuries may
the room.
easily result from foreign bodies
G The compressor is designed to
and blasted parts.
be used in dry rooms. It is
prohibited to use the
Never point the blow-out gun at
compressor in areas where
other persons and never use it to
work is conducted with sprayed
clean clothes that are still being
water.
worn.
16:38 Uhr Seite 9
GB
230 V ~ 50 Hz
1,5 / 2
2850
8
24
206
97
77
IP 20
25
Note the safety
instructions for paint
spraying!
Important! Note the pertinent
accident prevent regulations in
force in your area!
G Never process paints or
solvents with a flash point
below 21°C.
G Never heat paints or solvents.
G It is imperative to use filtering
equipment (face masks) when
processing harmful liquids.
Note also the information
concerning safety precautions
published by the manufacturers
of these liquids.
G Smoking is prohibited during
the spraying operation and in
the work room. Paint vapours
are highly flammable.
G Make sure there are no open
fires or open lights in the work
room. Sparking machines are
not to be used.
G Do not keep or consume food
and drink in the work room.
Paint vapours are harmful.
G The details and designations of
the Ordinance on Hazardous
Substances, which are
displayed on the outer
packaging of the processed
material, must be observed.
Additional protective measures
are to be undertaken if
9