Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
Immediately after and within 30 seconds, insert the batteries into temperature station
(see "Install and replace batteries in the temperature station"). Once the batteries
are in place, all segments of the LCD will light up briefly. Following the time as 0:00 will
be displayed and indoor temperature. If these are not displayed after 60 seconds,
remove the batteries and wait for at least 10 seconds before reinserting them.
3.
After inserting the batteries, the temperature station will start receiving data from the
transmitter. The outdoor temperature and the signal reception icon should then be
displayed on the Temperature station. If this does not happen after 3 minutes, the
batteries will need to be removed from both units and reset from step 1.
4.
In order to ensure sufficient 868 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the
temperature station and the transmitter (see notes on "Mounting" and "868 MHz
reception").
41
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
