Klarstein 10029714 Anschluss- Und Anwendungshinweise Seite 20

Problem
The Product is not working.
The Juice does not discharge
sufficiently or there is juice
discharging from pulp ejector.
The product stops while in
operation.
The pulp is too wet.
The motor is running with
loud noise and shaking
The receptacle is vibrating in
use
Check
Is the power cord connected?
Is the Juicer assembled correctly?
Has the power gone off?
Have you operated the Juicer for
over 20 minutes?
Did you assemble the rubber pad
correctly?
Did you use fresh ingredients?
Did you put too many ingredients or
anything else into the machine?
Did you force food into the juicer?
Did you put the ingredients with
hard seeds?
Is the strainer jammed?
Did you check that all parts are as-
sembled properlyand in correct po-
sition?
This is normal to make juice as the drum and main body is separated.
Solution
Check weather the power cord is
plugged into a 220-240V 50/60Hz
wall out let.
Assemble the product as described
in this user' s manual.
Assemble the product as described
in this user' s manual.
Turn off the appliance. Wait for a
while and reactivate the product. If
you want to use the product continu-
ously, pause the operation for 1 hour.
Assemble the rubber pad correctly as
described in this user' s manual.
Overripe fruits or vegetable may clog
in the motor.If you want to use the
overripe ingredients,use them after
soaking in mineral water for 10 min-
utes or more.
Turn switch to "REV"for several
second,stop,then to "STA".
Check if there is many ingredients
put into the machine.
Turn off the machine,and switch to
"REV"for several seconds,and then
turn to "STA"and try it again.
Check if there is too many pulp
blocked on the strainer, clean it at
once.
If the product is
properly,it is normal to make noise in
juicing from overripe fruit and vege-
tables. Turn the product off and clean
the drum.
assembled
20