Operation - Klarstein 10029714 Anschluss- Und Anwendungshinweise

Before use
1. Check all the parts (including the rubber pad/sealing/O-ring) are
assembled properly.
2. Place pitchers under both outlets (pulp/juice outlet).
3. Take off the "juice cap" on the juice outlet when juicing.
4. Insert the power plug.
Making juice
1. Put the ingredients slowly into the machine.
2. Use the pusher if necessary. The pusher is used to push some leafy
ingredients (which are difficult to put in) into the squeezing screw.
3. Do not the pusher to press all the ingredients into the hopper at a
time.
4. Turn the switch to "STA" to start juicing.
5. If ingredients got stuck, turn switch to "REV" for a few seconds
and then turn to "STA" again.
Under the work of squeezing screw, it will squeeze out juice and pulp at the same time. If the pulp has a hard
time coming out from the pulp outlet, please stop the machine and use the brush to clean it out.
6. Turn switch to "O" to stop operation after you have finished
juicing.

Operation

18