Other Components - ECOVACS DEEBOT3 Benutzerhandbuch

4.3 Other Components

Clean the Universal Wheel by removing any
hair tangled around it.
Wipe the Charging Contacts and Charging Dock Pins clean with a dry cloth.
Remove DEEBOT 3's battery if the robot will not be used for a long time. In case of battery leakage,
*
please remove the battery and wipe the battery slot clean while wearing protective gloves.
If DEEBOT 3's battery is fully discharged or not used for a long time, its capacity may
*
decrease, and need to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after
*
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT 3 uses a long life Ni-MH battery, and does not require frequent replacement. To
*
replace the battery, contact Customer Service or follow the below instructions:
a. Push the tabs on both sides of the Battery Pack to remove the Battery Pack.
b. Insert new Battery Pack and press until it's fully locked in place.
4. Maintenance
Wipe the Anti-Drop Sensors with a dry cloth
to maintain their effectiveness.
11
EN