Lcd Setting - PowerWalker VFI 6000CRM LCD Handbuch

3-6. LCD Setting

There are three parameters to set up the UPS. Refer to following diagram.
Parameter 3
EN
Parameter 1
Parameter 2
Programs available list for parameter 1:
Code Description
Output voltage
01
Output frequency
02
Voltage range for bypass
03
Frequency range for bypass
04
Reserved
05
Reserved
06
Reserved
07
Bypass mode setting
08
Battery maximum discharge time setting
09
Reserved
10
Reserved
11
12 Reserved
13 Battery voltage Calibration
14 Reserved
15 Inverter voltage Calibration
16 Floating charger voltage adjustment
17 Constant charger voltage adjustment
18 Charger maximum current setting
19 Battery capacity and groups setting
20 Backup time calibration
*Y means that this program can be set in this mode.
01: Output voltage

Interface
Parameter 1: It's for program alternatives. Refer
to below table for the programs to set up.
Parameter 2 and parameter 3 are the setting
options or values for each program.
Note: Please select "Up" or "Down" button to
change the programs or parameters.
Bypass
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Setting
Parameter 3: Output voltage
You may choose the following output voltage in parameter 3:
208: Presents output voltage is 208Vac
220: Presents output voltage is 220Vac
230: Presents output voltage is 230Vac
240: Presents output voltage is 240Vac
14
AC CVCF Battery
Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Battery Test
Y
Y
Y
Y
Y
Y
Y