Led Displays - AL-KO JET 4000 Betriebsanleitung

LED displays

LED DISPLAYS
START
STOP
Normal operating mode
Switching condition
Push the START /STOP button. Pump
switches on and starts to draw water.
Pump running.
Pushing the START/STOP button - the
pump switches off.
Special mode
In order to use a Hydrocontrol or a remote control switch, the pump must start automatically, the special
mode must be actuated for this.
Switching condition
Activating the special mode: Keep
the START/STOP button depressed
for 10 seconds when inserting the
mains plug.
Activating the special mode:Keep
the START/STOP button depressed
for 10 seconds when inserting the
mains plug.
467 774_c
LED display Function description
Initial commissioning: Suction and
PUMP ON LED
display lights up. pressure side connected, pump filled
FLOW CONTROL with water, water present on suction
LED display flas- side. Pump connected to the mains.
hes.
PUMP ON LED Pump feeds water. Water is removed
display lights up. on the pressure side.
LED displays off. Pump off
LED display Function description
All LED displays Pump now starts immediately. Mode
flash. is retained, even when removing the
mains voltage. Special mode active
when LED display PUMP ON flashes
in operation.
All LED displays Pump switches off immediately. Start
flash. again by pressing the START/STOP
button
17