Saxx 800001 Bedienungsanleitung Seite 17

2. Connection type
(Subwoofer in a surround system)
If your surround amplifier or receiver has a Line-subwoofer output (sub pre-out),
this can be used by connecting the subwoofer with a RCA cable. If your surround
amplifier has no such output, please use the first connection variant.
If you have connected your subwoofer to the Line-subwoofer output of your sur-
round amplifier, bass management is configured as follows:
Subwoofer:
Front/Centre/Rear:
When you turn on your subwoofer please proceed as described under the "Setup"
section below.
3. Connection type (some models)
(Subwoofer in Dolby / DTS system)
If your surround amplifier or receiver has an LFE output (Low Frequency Enhance-
ment), it can be used by connecting it to the LFE jack on the subwoofer
yes
large/small (depending on their size)
Sub Pre-Out
Surround-
Verstärker
EN
16