Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Thank you for purchasing a SaxxTec product! The following tips are designed to
assist you in connecting and operating your powered subwoofer, so that you obtain
the best possible result.
Read this entire manual carefully and follow all the steps specified for setting up
the system. Observe and follow all warnings and safety instructions as indicated
on the product and in the instruction manual. Keep these instructions close at hand
in case of any further questions.
•
Your unit is designed to operate on 115 V~ 60 Hz or 230 V~ 50 Hz mains net-
works. Please make sure before setting up that the appropriate operating volt-
age for your country is set at the rear of the product. (When delivered, this is
230 V~ 50 Hz).
•
Please ensure the power cord and other cables do not form a trip hazard, and
are protected from being crushed and stepped on.
•
Unplug the power cord from the socket during lightning storms or when unused
for long periods.
•
Our subwoofers are designed for use only in ordinary living spaces and for mod-
erate climates and are not to be operated in damp areas or tropical climates.
In addition, they should not be exposed to dripping or splashing water.
•
Defective fuses, if at all accessible from the exterior must be replaced by equiv-
alent fuse types. In this case the unit must be disconnected from the mains.
•
The temperature of the rear cooling surface/element may rise to above 60°C
during prolonged high-level operation. Therefore should not be touched during
this operation.
•
The active subwoofer should never have switches, controllers and input/output
jacks placed on the electronics side during operation, otherwise it may over-
heat. Make sure that a space of 5 cm adequate ventilation around the product
body remains free. The woofer, the bass reflex port and any existing air vents
must not be covered by newspapers, tablecloths and curtains or similar.
Safety Instructions
EN
12
Werbung
Inhaltsverzeichnis
