Start Up; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Baier BSS 509-H Originalbetriebsanleitung

 If necessary, peel the adhesive label in
the relevant national language off the
accompanying adhesive label sheet
and paste it over the German text on
the appliance.
The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pres-
sure.
 Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks with attachments with electrical
conductivity (included in the delivery).

Dry vacuum cleaning

– The appliance is equipped with a paper
filter bag fitted with locking lid.
Order No. Safety filter sack: 9039
(5 pieces)
18

Start up

Horn
Note: You can use this appliance to take up
all types of dust up to dust class H. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with AGW values.
– Unused flat-fold filters may only be
stored and transported in the packaging
(carton).
Illustration
– The lamella of the flat-fold filter should
not be touched during installation.
WARNING
The flat-fold filter and the safety filter sack
must never be removed during the dust ex-
traction process.
Installing the safety filter sack
 Release and remove the suction head.
Illustration
 Insert the safety filter sack.
Illustration
 Pull the safety filter sack over the con-
tainer.
 Insert and lock the suction head.

Wet vacuum cleaning

DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Close the suction connection
Illustration
 Precisely fit the plug into the suction
connection.
 Insert the plug up to the stop.
 Tightly close the suction connection
with the plug by turning it to the right.
Note: The accurate fit is ensured by means
of a "bayonet connection".
– 3
EN