Futech MULTICROSS 3D Bedienungsanleitung Seite 25

MULTICROSS 3D
Due to the special optics required to generate a continuous 360°
laser line, the underlying technology may cause differences in
brightness in different areas of the line. This may lead to different
ranges in hand receiver mode.
Slope mode
Do not release the transportation safety device. Slide the ON/
OFF switch into the center position and select the laser using the
selection button. Sloping planes and tilt can now be measured.
In this mode, thelaser lines no longer alighn automatically. This is
signalised by the laser lines flashing. In addition, the LED light (7)
remains red.
GENERAL INFO
Adverse Use
Use of the device without instruction.
Use outside of the intended limits.
Disabling safety features.
Removal of hazard notices.
Opening the device using tools, for example screw- driver, unless
this is specifically permitted for certain functions.
Modification or conversion of the device.
Use after misappropriation.
Use of devices with obviously recognizable damages or defects.
Use with accessories from other manufacturers without the prior
explicit approval of FUTECH.
Inadequate safeguards at the work site, for example when using
on or near roads.
Deliberate dazzling of third parties.
Controlling of machines, moving objects or similar monitoring
application without additional control and safety installations.
WARNING
Adverse use can lead to injury, malfunction and damage. It is the
task of the person responsible for the equipment to inform the
user about hazards and how to counteract them. The device is
not to be operated until the user has been instructed on how to
work with it.