Ordering Spare Parts; Disposal And Recycling; Maintenance And Cleaning - EINHELL WW 1200 Originalbetriebsanleitung

Anleitung WW 1200 - WW 2000_SPK1:Anl WH 2000 PTC SPK1
time. This is not a fault.
If the appliance should topple or fall over, the
power supply will be cut off by an integrated safety
switch in the appliance. The power supply
resumes as soon as the appliance is stood upright
again.
6.1 WW 1200 switch for heat output
(Fig. 1/ Item 2)
Low heat output (500 W): 500 W heat setting LED
lights up in heating mode
Medium heat output (700 W): 700 W heat setting
LED lights up in heating mode
Maximum heat output (1200 W): 1200 W heat
setting LED lights up in heating mode
6.2 WW 2000 switch for heat output
(Fig. 2 / Item 2)
Low heat output (1000 W): 1000 W heat setting
LED lights up in heating mode
Maximum heat output (2000 W): 2000 W heat
setting LED lights up in heating mode
6.3 Thermostat control (Fig. 1 / Item 3):
Switch on the desired heat output with the heat
output switch. Turn the control to "HI" until the
required room temperature is reached. The
temperature indicator LED comes on. Then turn the
control back until the temperature indicator LED goes
out. The thermostat control will switch the radiator on
and off automatically to maintain the room
temperature at an almost constant level. However,
this presupposes that the radiator has sufficient
output to cover the heating requirements for the
room.
Note: When the equipment is moved to a new
location, the thermostat will not work properly until
the equipment has adopted the ambient temperature.
6.4 Overheat cut-out
In case of excessive heating, the appliance shuts
down automatically. If this occurs, turn off the
appliance, disconnect the mains plug and wait a few
minutes for the appliance to cool. After eliminating
the cause (e.g. a covered air grille), the appliance
can be switched on again.

7. Maintenance and cleaning

Before carrying out any cleaning and maintenance
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
26.08.2009 13:35 Uhr
Maintenance and repair work may only be carried
out by an authorized electrical servicing contractor
or ISC GmbH.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or ISC GmbH in
compliance with the relevant regulations.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8. Storage
The radiator has to be stored in a dry place, covered
if possible.

9. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Seite 11
GB
11