Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ALLIGNING UNIT DOORS WITH THE FRIDGE-
FREEZER DOORS
The appliance is supplied with fittings (slides and slide brackets) to align
the fridge-freezer doors with the doors of the unit
Fix the slide on the inside of the unit door, at the height you want. Make
sure it is approximately 20 mm from the outside edge of the door.
Open the doors of the unit and fridge. Position the slide bracket around
the slide and secure to the appliance door.
Mark the holes for the screws and drill with a 2.5 mm diameter bit.
Fit the appliance door to the door of the unit, using the slots on the slide
bracket as a guide.
ENSURING YOUR FRIDGE-FREEZER
WORKS PROPERLY
After fitting the appliance, place the rear of the unit against the wall to
prevent access to the compressor unit.
To make sure the fridge-freezer works properly, air must circulate to cool
the condenser which is situated at the bottom of the appliance.
The unit must have a rear outlet with top opening that is not obstructed and
a front opening which is covered by the ventilation grid.
Size of the unit cut outs.
Room to leave between the unit and ceiling.
4 GB
Werbung
