Intended Use - ResMed AirFit F10 Gebrauchsanweisung

English
This document provides the user instructions for:
 AirFit F10 (blue headgear) and AirFit F10 for Her (pink
headgear) collectively referred to as AirFit F10.

Intended Use

The AirFit F10 is a noninvasive accessory used for channeling
airflow (with or without supplemental oxygen) to a patient
from a positive airway pressure (PAP) device such as a
continuous positive airway pressure (CPAP) or bilevel system.
The AirFit F10 is:
 to be used by patients (weighing >66 lb (30 kg)) for whom
positive airway pressure therapy has been prescribed
 intended for single-patient reuse in the home environment
and multipatient reuse in the hospital/institutional
environment.
Using the mask
 Refer to the Technical specifications section in this user
guide for mask setting options.
 Follow the instructions provided by your physician or sleep
therapist.
 To fit, remove, disassemble or reassemble your mask,
follow the illustrations at the front of this guide.
 Do not overtighten the headgear straps. If you feel air-leaks
you may need to:
–
refit or reposition your mask
–
adjust your headgear
–
check that your mask is assembled correctly
–
contact your physician or sleep therapist to have your
mask refitted.
 For a full list of compatible devices and mask setting
options, see the "Mask/Device Compatibility List" on
www.resmed.com on the Products page under Service &
Support.
 The mask system does not contain natural rubber latex,
PVC, DEHP or phthalates materials.
 Use a standard conical connector if pressure readings
and/or supplemental oxygen are required.
Cleaning the mask at home
The mask and headgear can only be gently handwashed in
warm (30°C) water using mild soap.
Daily/After each use:
 Disassemble the mask components according to the
disassembly instructions.
 Handwash the separated mask components (excluding
headgear and soft sleeves).
 To optimise the mask seal, facial oils should be removed
from the cushion after use.
 Use a soft bristle brush to clean the vent.
 Inspect each component and, if required, repeat washing
until visually clean.
 Rinse all components well with drinking quality water and
allow to air dry out of direct sunlight.
 When all components are dry, reassemble according to the
reassembly instructions.
Weekly:
Handwash the headgear and soft sleeves.
6